　

Condor

Specifications:
Wingspan: 165"
Length: 66.5"
Weight approx.: 186-222 oz
Controls: A/E/R/Flaps/Spoilers
Options: Tow Release

The Performance-Optimized Sailplane

The CONDOR was designed and built upon the experiences gained at F3B contests. Minimal sink rates and a high range of speed were top priorities. The CONDOR features the Quabeck airfoil which provides stable flight characteristics and a wide range of performance. The average R/C system can fully manage all controls of the CONDOR, yet a modern computer R/C system allows for enhanced mixing options and pre-sets for optimization of thermal, distance and speed flights.

　Winch launch the CONDOR and seek thermals effortlessly. Center a thermal and almost disappear just beneath the clouds. Then, show your friends what an aerobatic speed-run is all about! The CONDOR was made to be flown this way!

CONDOR - What Performance!

pre-built, specially designed MULTIcontest wings
3-piece wing with strong center for high strength

wings with strong spars reaching all the way into the outer wing panel

　
pre-finished obechi leading edge and wing tips.
factory built-in double-height MULTIPLEX-Super-Spoilers.
factory built-in joiner tubes for inner and outer wing panels.

Factory built-in special root ribs on inner and outer wing panel.
servo cut-outs and wiring installed for servos
pre-fabricated elevator with joiner tube and rudder
colored, finished GFK-canopy and wing center piece
white, strong MULTIPOXY-fuselage
elevator with "no play" bell-crank linkage

			Kit Contents: white epoxy fuselage Obechi-sheeted wings with finished leading edge and built-in spoilers Rudder and tail-feathers are pre-built obechi over foam complete hardware set
	Tuning Set CONDOR Performance of the CONDOR can be increased, especially at higher speeds. The gap seals minimize drag at the flaps and ailerons. The kit includes all necessary parts and instructions.