     *** ZR-5700/ZR-5800 Enabler/updater V1.1 (1/28/97) ***

Installing the Enabler:

Before using ZR-AP2 with your Zaurus ZR-5700/5800, you must install the
Enabler. This Enabler also fixes a number of other minor problems with the 
ZR-5700/5800 including:

(1) A CompuServe E-mail formatting problem (users receiving mail from a
    Zaurus user see one long line of text).
(2) A CompuServe forum "via mail" problem where it is actually posted
    as a public message.
(3) A Spreadsheet problem that prevented users from opening imported
    worksheets using special fonts
(4) A Spreadsheet problem  that incorrectly handled the ATAN2() 
    function.

Also note that the first release of this enabler/updater (Enabler.exe 
file dated 12/5/96) caused a problem that would lose characters in an 
Internet Mail message sent using the built-in CompuServe software. 
This problem has been fixed in this version 1.1 (1/28/97) of the 
enabler/updater,


Caution:
* Just as a precaution, backup your Zaurus before running the enabler.
* Do not use this Enabler with the ZR-5000, ZR-3000, or ZR-3500x.
* Do not press the ON key or the RESET switch while installing the Enabler.
* Try again if the installation is unsuccessful. Otherwise, the Zaurus 
  may not work properly.
* About 64K available memory on your Zaurus is required to install the
  Enabler. Once installed, this memory is then available for you. The 
  update takes up no user memory.
* Use fresh batteries and/or the AC adaptor (EA-23E).

Step by Step Instructions:

1. Connect the cable or infrared adaptor to your PC and your Zaurus.

2. Touch TOOLS on your Zaurus and select PC Link.

3. Select Wireless or Cable (depending upon which "cable"
   you are using) then touch OK.

4. Run the Enabler.exe program.

5. If you need to change the communications port, press S.

6. Press Y to start the installation of the update.

7. When finished, your Zaurus will restart automatically.
