|
|
|
|
Drip Timer Another method of time delay for explosives that are detonated by
electric means, is the drip timer. Fill a 'baggie' with water and
then add as much salt as the water will hold. Seal it, leaving some
air inside. Then, tape the two contact wires from which the circuit
has been broken, to the inside of a large cup. Place the baggie on
the cup. Poke a hole in the top of the 'baggie', where there is
air, and then make a hole in the bottom to let the water drain into
the cup. As any Einstien figures, the salt water level in the cup
will eventually cunduct electricity at the moment both wires touch
water, thus completing the circut. I have yet to try this timer
out, and I got the plans from a total idiot, phreaker nonetheless,
and doubt it would work with any power source under 12v.
------------------007 |
|
Copyright © 2000 *O**O**H Inc.
|
