Modifying the Valve

I will have pics and a article up as soon as I get a chance...
I just followed the instructions of this article...

It requires:

1 drill
3/16 drill bit
Some kind of brush to scrub burs out of the valve

1. Take the valve at the 3o'clock position and drill it out with a 3/16" drill bit.
BE CAREFUL NOT TO DRILL INTO THE OTHER VALVE SETTING BELOW... THIS MEANS YOU!!!

2. Take the valve, SAND the newly modified valve setting to remove burs... Take it then and scrub it up in some
warm soapy water with a brush to get all the dirt and metal shavings out...

3. Relub the valve and put it back in your gun and your ready to Rock n Roll....

Return to the VM-68 Page

This Page and Images are Copyrighted by the Owner of the Website...

E-Mail Me