Home
Cracks
Trainers
Emulators
Multiplayer
PSX
Forum


 
 


Key-CD Backup [PSXNIC]

These Backup Instructions may only be used to create a backup of your original Bleem! Key-CD for personal use.

Introduction
Here are the Bleem! Key-CD backup instructions made by PSXNIC - Forum.

This is an easy way to copy the Bleem! Key-CD, no need to replace unreadable sectors with ones from another CD, what just is needed is a very good CD-Reader which is will ignore unreadable sectors. For these instructions a Teac CD-532S has been used.

NOTE: Keep in mind that these instructions may fail as a very good CD-Reader (Teac CD-532) was used to read parts of the DATA tracks.

For more info on CD-Readers which are capable in reading unreadable sectors from an protected CD.

Backup Instructions
  • Start DiskJuggler (1.05.340 or higher).
  • From the action-bar choose File and select New.
  • In the New Task window select CD Player to CD Image and click OK.
  • In the Task 1 - CD Player to CD Image window select the following settings (all other settings should be left default):
Source & Destination Tab
Source Select Source CD-Reader
Destination Enter/Browse a Destination Filename
Advanced Tab
Read speed Max
ISRC and UPC Select
Scan gaps/indexes  Select
Raw read/write Select
Ignore read errors Select
Action
When ready Click Start
 
  • When ready insert a CD-R in the CD-Writer.
  • From the action-bar choose File and select New.
  • In the New Task window select CD Image to CD Recorder and click OK.
  • In the Task 2 - CD Image to CD Recorder window select the following settings (all other settings should be left default):
Source & Destination Tab
Source Enter/Browse the Source Image Filename
Destination Select DestinationCD-Writer (if needed)
Advanced Tab - Suggested  Image Format
Mode Mode 1
Block 2352
Advanced Tab - Misc
ISRC and UPC Select
Scan gaps/indexes  Select
Raw read/write Select
Advanced Tab - Action
Pull-Down menu Select Write or Write and Verify
Advanced Tab - Methode
Slower/Faster Select 1x or any other desired speed
 
  • When ready click Start to start the copy process.
NOTE: When track 7 is being read the following error messages will be displayed in the event/description window:

Supplying 1 dummy block at address 06:27:02 MSF (CDB: 2800000070ca000010000 , Status : 040002 , Sense : 031501) Random or mechanical position error)

Just ignore these errors as they are caused by several unreadable sectors which are on track 7 (463.2Mb).

After 4 hours and 30 minutes of reading you will have a perfect image of the original CD (all unreadable sectors have been replaced by readable ones) which means you will have exactly the same TOC (Table Of Contents) of original: 

  • 2 DATA tracks (track 1 & 7)
  • 32 AUDIO tracks
 
 
 
 
 
 
* = Backup Protected