Fenton PowerPal UPS

• Every PowerPal model has dual RJ11/RJ45 surge protection ports to protect against surges coming through telephone/modem or network 

• Every PowerPal has an RS232 interface port 

• Every PowerPal is bundled with  smart software for UPS monitoring and automatic safe shutdown of your computer system. For use with Windows NT, 2000, 98, 95, Novell Netware, Linux, and BSD! Optional software for other operating systems also available. 

• Fenton's intelligent overload and short circuit protection feature works in both AC and battery operation modes - PowerPal warns you of small overloads and shuts down during short circuit or high overload conditions to protect you and your equipment and to help you avoid nuisance fuse blows.

• Battery test function and battery replacement indicator.

• Site wiring fault indicator alerts you to potentially hazardous electrical wiring.

• User replaceable, hot-swappable batteries for convenient and economical battery replacement (280/425/660 only) 

• Smart electronic on/off switch lets you turn on UPS with or without AC utility power available -  PowerPal's battery power is available whenever you need it. And the delayed off feature helps prevent accidental turning off of the UPS 

• 50/60 Hz. auto-sensing 

• UL and cUL listed for safety and performance

• Additional features of models L1000/1400: 

• Four additional visual indicators: boosting voltage, bucking voltage, load level percentage of maximum load, battery charge level as a percentage of full charge Six output receptacles.

• Circuit breaker for convenient resetting instead of replacing fuse when overload/short circuit.

• Built-in cooling fan in rear of UPS for optimal battery performance and runtime 

RUNTIME CHART 

All runtimes (given in minutes) are approximate only and will vary depending on actual power draw of connected equipment, age of UPS battery, and other variables. For further help estimating runtimes please call Fenton Technologies. 
 

SPECIFICATIONS CHART

• L280 L425 L660 L1000 L1400

• Voltage: 115 VAC (A models) or 230 VAC (E models) (different models, not switchable)

• Frequency: 50/60 Hz. auto-sensing

• VA Rating 280 425 660 1000 1400

• Wattage 180 270 420 670 950

• Voltage Regulation "Boost and buck" automatic voltage correction

• increases output by 12.5% if input is 14 - 27% below nominal and

• decreases output by 12.5% if input is 10 - 22.5% above nominal

• Receptacles 2 3 4 6 6

• Energy Rating: 320 joules instantaneous response - hot, ground, & neutral

• Test Standard: IEEE-587 A & B

• Tel/Network: Dual RJ11/45 surge protection port

• Filtering: EMI/RFI full time suppression

• Attenuation: Better than 45 dB @1 MHz for normal/common mode

• Type: Sealed, lead-acid maintenance-free

• Recharge Time: Six hours to 90% charge (typical)

• Under/Over Voltage Switch to battery output when out of regulation range 

• Overload/

• Short Circuit: Fuse and current limited for utility and battery modes

• Fuse/

• Circuit Breaker: 280/425/660: 6.3 A 250 V T type; 1000/1400: 9 A circuit breaker

• Low Battery: Two stage alarm, no battery drain after automatic cutoff

• Visual Indicators: Normal, battery, overload, replace battery, site wiring fault 

• (1000/1400: also battery level, load level, boost voltage, buck voltage)

COMMUNICATION

• COM Port: Microprocessor-controlled DB9, RS232 & contact closure signals

• Dimensions:280/425:107x170x350mm;660:107x170x385 mm;1000/1400:220x170x440 mm

Net Weight 12 lbs. 15.5 lbs. 21 lbs. 42 lbs. 57 lbs.

SAFETY APPROVALS UL, cUL, CE