Layout - Graphic - 18.6 KB
JUMPERS SETTINGS
Display adapter select (P6)
Pin 1 - 2 | ON | Monochrome Adapter |
Pin 2 - 3 | ON | Color Graphic Adapter |
Pin 1 - 2 | ON | Use 512K ROM size |
Pin 2 - 3 | ON | Use 256K ROM size |
Pin 1 - 2 | ON | Battery enable |
Pin 1 - 2 | OFF | Battery disable |
Power good signal (P3)
Pin 1 - 2 | ON | Signal supply by main board itself. |
Pin 2 - 3 | ON | Signal supply from outside switching power |
Pin 1-2 | ON | Disable memory parity check |
Pin 1-2 | OFF | Enable memory parity check |
Connector Definitions:
Power LED and keylock connector (P7)
5-PIN SINGLE IN LINE BERG
STRIP.
Pin | Description |
1 | LED power |
2 | Gnd |
3 | Gnd |
4 | Keyboard inhibit |
5 | Gnd |
Speaker connector (P8)
4-PIN SINGLE IN LINE BERG
STRIP.
Pin | Description |
1 | Data |
2 | Data (Same as Pin 1) |
3 | + 5V |
4 | +5V |
Battery Connector (P5)
4-PIN SINGLE IN LINE BERG
STRIP.
Pin | Description |
1 | 6 VDC |
2 | Not Used |
3 | Gnd |
4 | Gnd |
Turbo LED connector (P9)
2-PIN SINGLE IN LINE BERG
STRIP.
Pin | Description |
1 | + |
2 | - |
Hardware reset connector (Pll)
2-PIN SINGLE IN LINE BERG
STRIP.
Pin | Description |
1 | + |
2 | - |
Hardware turbo connector (P10)
Turbo: When "Short".
Normal: When "Open".
Switching from normal to turbo mode :
Press and hold "CTRL" and ALT keys, and press the "+" key.
Switching from turbo to normal mode :
Press and hold "CTRL" and "ALT" keys, and press the "-" key.
Page updated 98/07/14