1. All type of hydraulic press (up to 2,500 Ton Press in any dimension)
2. Sharing Machine-Metal./Steel.
3. Bending Machine-Metal/Steel.
4. Lifting Devices-Concrete structural, many cases replace crane & container lifting
5. Injection molding machine-Plastic, FRP (Fiber reinforce plastic/polyester, Special materials etc.

Technology advantage.

1. Parallel drive system
2. Low cost system
3. Easy to manufacture & maintain locally.
4. Can replace most of common hydraulic system.

Of course a COMPUTER-CONTROL will be available too for TANO-HPPU-SYSTEM

1. No additional cost for a Parallel-guiding-System. Under all conditions PARALLEL-DRIVE, no correction of a deviation.
2. With the TANO-MACHINE it is not possible to damage the DIE/MOLD or TOOL or the TANO-MACHINE it-self by wrong-placing of the DIE/MOLD or TOOL.
3. The weight of a TANO-MACHINE is much lower (60 to 80%) than of a conventional machine with the same technical data.
4. The result: The cost for the FRAME of a TANO-MACHINE is about 60 to 80%, depending on the type of machine.
5. Low-cost for investment, maintenance and repair.
6. Lower POWER-CONNECTION to the E-net and smaller size of the DRIVE-MOTOR for compressor or centrifugal-pump. Result: Lower cost for ENERGY and lower INVESTMENT
7. Very high CONTROL-COMFORT with simple and relatively low-cost control-equipment.

HOW IT IS WORKING :

1. The TANAO-HPPU-System is a LINE or AREA-SPECIFIC Power Supply System with an adjustable Maximum-Power per Length or Area-Range.
2. The TANO-System is working with water in a pressure-range up to 80 Mpa (30 bar).
3. The power-supply for drive is either by pressure-air of 1 Mpa (10 bar) or by electric power via a Centrifugal-Water-Pump for 3 Mpa ( 30 bar).
4. All equipment for control is in the pressure-range of 1 Mpa air or 3 Mpa water. In the Mid and High-Pressure-Range are only Pressure-Gages in "Closed circuits".
5. The TANO-HPPU is a special combination of different types of Hydraulic-Cylinders, all working in slow motion only. Not any fast-moving part is used in the TANO-System.
6. The High-pressure-System is a "LEAK-FREE CLOSED SYSTEM".
7. The TANO-System needs a minimum of two power-cylinders for Line-Application (as for press-break or shearing-machines) and four (three for special application) power-cylinders for Area Applications (as for power-press-machines). The number of cylinders is limited only by the size of the HYDRAULIC-PNEUMATIC-POWER-UNIT (HPPU).'
8. The pressure-application to the power-cylinders is controlled by an open (for air-drive) or closed (for water-drive) PRESSURE-AIR-SYSTEM in the LOW-PRESSURE-RANGE.
9. Because the HYDRAULIC-FLUID is un-compressible WATER, the PARALLEL-DRIVE is also independent of the LOAD of each POWER-CYLINDER. Even if the total load on a working-machine is only on one side, the POWER-PLATES of the machine will remain exactly parallel and the supplied power to the DIE/MOLD will be according to it's size (LINE or AREA-SPECIFIC POWER-SUPPLY)