1. The Board
of Directors will have the option to cut classes and
or shorten the pulling track in order to save time. These
options will only be used when a time limit is imposed
for the program 2. The sled
operator has the option to incorporate the floating
finish line when possible.
3. Shifting
gears either hydrostatic, automatic, or gear type, is
permitted as long as forward motion of the sled does not
stop.
4. Once hooked
to the sled, there are no substitutions of machines for
that class. If a machine breaks before hooking up you may:....
Pull with another machine .... Hook to
the sled without attempting to move for 5 points, or if
you can move the sled you will get place points.
5. Only 2
drivers per machine per class. Driver may enter not more
than 2 machines per class. Members can only receive the
points from 1 machine and must specify which machine will
receive the points when they register. That decision
cannot be changed.
6. Foot or hand
throttles are acceptable but with no wires, chains,
strings, or tarp straps.
7. No turbos,
superchargers, or blowers in any class except Open-02,
Open-03, and Open-04.
8. No unit can
register until it has been checked by tech personnel. No
changes can be made to the machine after teching except
weight changes or minor adjustments. Otherwise a second
tech check is necessary.
9. When
registering you are to fill out your entry form and hand
it to the girls at the table. You are NOT
to roll the dice until after you have handed your form to
the girls and they are watching you roll. If you roll
before the girls are watching you, you must roll again.
10. No nitrous
oxide or pressurized gas tanks in any class. Electric
fuel pumps are allowed but must be connected to a kill
plug.
11. No alcohol
in any class except the open classes. (YOU MUST NOTIFY
TRACK PERSONNEL.)
12. Driver is
considered disqualified when any part of machine touches
the boundary lines. Boundary lines will be extended 20'
beyond the full pull line and a foul cannot occur after
that line.
13. No portion
of the machine my interfere with sled hook-up or un-hook. 14. All power
must be transmitted through rear wheels.
15. Every puller
has 2 minutes after the sled returns to it?s staging
position to hook to the sled and make an attempt to pull.
You may not drop because of breakage. (Refer to rule #4)
16. First puller
in every class will have the option of taking that pull
or coming back in 4th position unless puller
fouls.
17. Class can be
restarted only after two machines have full-pulled. Class
must be restarted if necessary, before the 6th
puller. In a restart, all machines pulled before the
restart will drop to the end of the class and the next
puller in the line-up is the first puller. The option to
come back is eliminated. Class cannot be restarted after
50% of the class has been pulled.
18. Pullers have
2 attempts to move the sled if your first attempt does
not exceed the 35' mark and you did not foul Your 2nd
attempt MUST be taken within 2 minutes after the sled
returns. The machine may not leave the track before your
2nd attempt. Once hooked to the sled and
breakage occurs there will be no refunds issued. If the
flagman forgets to tell the driver that he has a 2nd
attempt and the driver leaves the track, track personnel
must allow the driver to re-enter the track for a 2nd
attempt.
19. 2 riders on
the same machine or 1 person pulling 2 machines may drop
3 positions to separate. 20. In all pull-off
situations, you only have 1 attempt to move the sled. If
more than 1 person fouls in a pull-off, a reading will be
taken where they fouled and places will be determined
according to their reading. Once a pull-off is started
everyone must pull before the sled can be re-weighted.
21. There will
not be a yearly rules meeting. Then rules meetings will
now be held every 3 years.
22. All rules
are final and cannot be changed during the 3 year period
unless voted on by a majority of members present at the
meeting.
|